Sink Waste Combination Overflow Plug with Chain 40mm 1.5" (Square)

1. Check and familiarise yourself with all the components.

2. Take the main body of the waste (F,G,H) to the sink, ensuring washers (E) and correct overflow washer (I) is in place ready for installation.

3. Locate the overflow body (H) and washer (I) centrally at the rear of the sink overflow hole, ensuring it is flush with the wall of the sink.

4. Keeping this central, take the overflow screw (J) and tighten into the thread, please do not over tighten.

5. To secure to the waste outlet on the sink, place the foam washer (D) onto the sink outlet hole , and place the steel waste grating (C) on top. Locate the waste body (F) on the underside of this hole ensuring the rubber washer (E) is flush with the underside of the sink. Now everything is in place take the screw (B) and tighten. Please do not over tighten.

6. Please check the overflow pipe (G) is not twisted or kinked and both ends are secure.

7. To check all joints fill the sink with water and inspect for any leaks. We advise doing this in stages starting with a small amount of water, before fully filling sink.